1-INCH DRIFT
THE 1-INCH DRIFT
THESE DRIFTS ARE FORGED FROM NEW 1-INCH ROUND 1045 STEEL. WE USE 1045 FOR OUR DRIFTS BECAUSE IT IS TOUGHER THAN MILD STEEL BUT CAN STILL BE COOLED IN WATER FOR RAPID REUSE.
EACH DRIFT FEATURES A LONG ENTRANCE TAPER, A SHORT SECTION OF PARENT MATERIAL AND THEN A REVERSE TAPER. THIS ALLOWS YOU TO ENTER THE HOLE YOU ARE DRIFTING AND DRIVE THE DRIFT ALL THE WAY THROUGH AS EASILY AS POSSIBLE. THE REVERSE TAPER ALLOWS THE DRIFT THE CLEAR THE HOLE AND FALL OUT.
MATERIAL: 1045 TOOL STEEL
LENGTH: 7-INCHES (APPROXIMATELY)
THE 1-INCH DRIFT
THESE DRIFTS ARE FORGED FROM NEW 1-INCH ROUND 1045 STEEL. WE USE 1045 FOR OUR DRIFTS BECAUSE IT IS TOUGHER THAN MILD STEEL BUT CAN STILL BE COOLED IN WATER FOR RAPID REUSE.
EACH DRIFT FEATURES A LONG ENTRANCE TAPER, A SHORT SECTION OF PARENT MATERIAL AND THEN A REVERSE TAPER. THIS ALLOWS YOU TO ENTER THE HOLE YOU ARE DRIFTING AND DRIVE THE DRIFT ALL THE WAY THROUGH AS EASILY AS POSSIBLE. THE REVERSE TAPER ALLOWS THE DRIFT THE CLEAR THE HOLE AND FALL OUT.
MATERIAL: 1045 TOOL STEEL
LENGTH: 7-INCHES (APPROXIMATELY)
THE 1-INCH DRIFT
THESE DRIFTS ARE FORGED FROM NEW 1-INCH ROUND 1045 STEEL. WE USE 1045 FOR OUR DRIFTS BECAUSE IT IS TOUGHER THAN MILD STEEL BUT CAN STILL BE COOLED IN WATER FOR RAPID REUSE.
EACH DRIFT FEATURES A LONG ENTRANCE TAPER, A SHORT SECTION OF PARENT MATERIAL AND THEN A REVERSE TAPER. THIS ALLOWS YOU TO ENTER THE HOLE YOU ARE DRIFTING AND DRIVE THE DRIFT ALL THE WAY THROUGH AS EASILY AS POSSIBLE. THE REVERSE TAPER ALLOWS THE DRIFT THE CLEAR THE HOLE AND FALL OUT.
MATERIAL: 1045 TOOL STEEL
LENGTH: 7-INCHES (APPROXIMATELY)